O2 eliminator. You can also download the. Power Commander software and
latest maps from our web site at: www.powercommander.com. THE IGNITION ...
2008 HONDA CBR125R Installation Instructions Parts List 1 1 1 1 1 2 2 2 1 1 1
Power Commander Installation Guide USB cable CD-ROM Power adapter Dynojet decals Power Commander decals Velcro® Strip Alcohol Swab Port plug set O2 eliminator
You can also download the Power Commander software and latest maps from our web site at:
www.powercommander.com
THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 139-411
www.powercommander.com
2008 Honda CBR125R - 1
PCIII harness
FIG A
Remove both seats.
2
Prop the front of the fuel tank up.
3
Lay the PCIII in the tail section and route the cable along the frame (Fig. A).
4
Disconnect the stock connector from the bikes injector, this connector is covered by a rubber boot (Fig B).
5
Plug the PCIII connectors inline with the stock harness and injector (Fig C).
FIG C
Unplug
FIG B
1
139-411
www.powercommander.com
2008 Honda CBR125R - 2
FIG D
PCIII ground
FIG E
6
Locate the TPS on the left side of the bike (Fig D).
7
Crimp the supplied wire-tap onto the YELLOW/BLACK wire (Fig E).
8
Connect the GREY wire from the PCIII to this wire tap.
It is recommended to use dielectric grease on these connections.
9
Remove the battery cover and attach the PC ground wire to the negative side of the battery (Fig F).
10 Remove the right side fairing.
FIG F
11 Locate the stock O2 sensor. This is the wire coming from the right side of the cylinder head near the exhaust.
Unplug
12 Unplug the O2 sensor (Fig F).
6-69
Ignition Module
The stock O2 sensor will no longer be connected to anything. Secure it out of the way.
08-09 Honda CB 1000R - 3
FIG G
O2 eliminator
13 Plug the Dynojet O2 eliminator into the stock wiring harness. 14 Route the O2 eliminator harness to the inside of the frame near the thermostat housing (Fig. G).
FIG H
Ground 15 Ground the other end of the Dynojet O2 eliminator to the bolt of the thermostat housing (Fig. H).
FIG J
16 Secure the PCIII in the tail section using the supplied velcro. Make sure to use the alcohol swab to clean both surfaces before attaching.
139-411
17 Bolt the fuel tank back into place. Reinstall the fairing and seats.
