BMW Parts and Accessories Installation Instructions

13 downloads 192 Views 163KB Size Report
Retrofit White Direction Indicator Lights / rear lamps facelift E46/5 for BMW 3 Series ... This is the only place where appropriately trained technical personnel are ...
BMW Parts and Accessories Installation Instructions

F F 46 46 0211 0211 EVA EVA

Retrofit White Direction Indicator Lights / rear lamps facelift E 46/5 for BMW 3 Series (E 46) Technical knowledge is required

Order no. 01 29 9 0 006 733 XI/02 Printed in Germany

Contents 1 2 2.1 2.2

Important notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Preparatory work . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation of white direction indicator lights / rear lamps facelift E46/5

Page 1-1 2-1 2-1 2-1

1. Important notes Installation time approx. 1 hour, which can vary according to the condition and fittings of the vehicle.

Target Group Conversion using the installation kit, White Direction Indicator Lights / rear lamps facelift (E 46/5), should be carried out exclusively by a BMW technical workshop. This is the only place where appropriately trained technical personnel are available who have the necessary tools and auxiliary materials.

Safety notes BMW accepts no liability for damage which occurs as a result of not following the work sequence and safety instructions. In addition, any warranty claim against BMW AG is extinguished in the event of improper fitting and handling which diverges from the fitting and operating instructions. Electrical cables should be installed in such a way as to exclude any possibility of them being kinked, chafed or crushed.

Assembly notes Operations on the lighting units are in each case shown on only one side of a vehicle. Operations on the other side of the vehicle should be carried out appropriately in mirror image.

Required tools and auxiliary materials Flat-tip screwdriver 1/4 inch reversible ratchet 1/4 inch socket wrench insert SW 10 mm 1/4 inch extension

Only for BMW 3 Series Compact (E46/5) and BMW 3 Series (E46) from 09/2001: Phillips screwdriver

EN/1-1

2. Installation Notes Refer to the safety instructions in section 1. The installation of the accessory is based on the conventional workshop information.

2.1 Preparations Open the bonnet and boot lid. Print out the error memory. Disconnect the battery. BMW 3 Series touring (E46/3) only Remove the boot trims on both sides BMW 3 Series Saloon (E46/4) after 09/2001 only Remove the warning triangle.

2.2 To install the white indicator lights / rear lamps facelift (E 46/5) Unfold folded page X-X A All models before 09/2001 apart from the BMW 3 Series Compact (E46/5) Insert a flat screwdriver (1) vertically into the body recess (2), press down the retaining clip for the front indicator light (3) and pull out the front indicator light (3) in the direction indicated by the arrow. B All models after 09/2001 and the BMW 3 Series Compact (E46/5) Insert a Philips screwdriver (27) vertically into the body recess (28) and undo the screw (approx. four turns). Pull out the indicator light (29) in the direction indicated by the arrow.

C Disconnect the plug (4) from the lamp socket (5). D All models before 09/2001 apart from the BMW 3 Series Compact (E46/5) Connect the plug to the lamp socket for the front white indicator light (10). Insert the retaining clip (6) for the white indicator light (10) into the holder (7) in the direction indicated by the arrow. Ensure that the guide rail (8) runs into the holder (9) as you slide in the front white indicator light (10).

If you fail to follow the sequence for the installation work outlined above, the guide rail (8) and the retaining clip (6) may catch as you slide them into position and break. In addition you should ensure that the sealing lips on the front white indicator light (10) do not move or become loose during the installation work. All models after 09/2001 and the BMW 3 Series Compact (E46/5) Install the front white indicator light (10) by following the instructions for removal (see Figure B) in reverse. E Push the additional indicator light (11) in the direction indicated by the arrow. Lever the additional indicator light (11) out of the recess using the flat screwdriver (12).

Position the flat screwdriver (12) with care to lever out the additional indicator light (11) to avoid damaging the paintwork. F Disconnect the plug (13) from the original lamp socket (14) in the car. Connect the plug (13) to the lamp socket for the additional white indicator light and then press the additional white indicator light into the body recess. G All models before 09/2001 apart from the BMW 3 Series Compact (E46/5) Release the side trim (15) in the boot and pull it away in the direction indicated by the arrow. Press the cap (16) on the lamp holder (17) in the direction indicated by the arrow and release the lamp holder (17). H BMW 3 Series Saloon (E46/4) after 09/2001 only Release the lamp holder (33) by turning the star handle (34) (approx. 1/4 of a turn) and swing out the lamp holder (33).

I All models apart from the BMW 3 Series Compact (E46/5) Disconnect the plug (18) from the adapter on the lamp holder (19). J BMW 3 Series touring (E46/3) and BMW 3 Series Coupé (E46/2) only Unscrew the hexagonal screw (20). K BMW 3 Series Saloon (E46/4) before 09/2001 only Remove the stopper (21) from the boot sill (22) and unscrew the hexagonal nut (23) behind the boot sill (22) using an extension. Unscrew the hexagonal nuts (24). L BMW 3 Series Saloon (E46/4) after 09/2001 only Remove the stopper (35) from the boot sill (22) and unscrew the hexagonal nut (37). Move the boot trim (38) to the side and unscrew the hexagonal nut (39). Remove the plastic holder with the hexagonal nut (40). M BMW 3 Series Coupé (E46/2) only Remove the trim (25) in the direction indicated by the arrow. N BMW 3 Series Compact (E46/5) only Move the boot trim (30) to the side. Disconnect the plug (31) from the original lamp holder in the car. Unscrew the hexagonal nuts (32). 0 Remove the tail light (26) from the body in the direction indicated by the arrow. Insert the tail light with the white indicator light into the holes in the body and secure it with hexagonal nuts. Connect the plug to the adapter on the lamp holder in the tail light with the white indicator light. All models before 09/2001 apart from the BMW 3 Series Compact (E46/5) Press the lamp holder into the mounting until the cap on the lamp holder engages. BMW 3 Series Saloon (E46/4) after 09/2001 only Secure the lamp holder by turning the star handle. Assemble the car again by following the instructions for its dismantling in reverse order.

A

B 1

28

27

2 3

29 F 46 0113 EVA

C

F 46 0760 EVA

9

D

5 4

10 7

8

F 46 0114 EVA

E

6

F 46 0115 EVA

F 11

12 13 14

F 46 0116 EVA

G

F 46 0117 EVA

H 17 34

15

33

16 F 46 0350 EVA

046 0865 V

I

J 18 20

19 F 46 0120 EVA

F 46 0119 EVA

K

L

24

40 38

23 22

39

21

F 46 0351 EVA

M

37

35 046 0866 V

N 25

30

32

31 F 46 0121 EVA

F 46 0761 EVA

O

26

F 46 0122 EVA

EN/2-17