Home
Search
Collections
Journals
About
Contact us
My IOPscience
Erratum: Manipulation and online monitoring of micro-replication quality during injectioncompression molding
This article has been downloaded from IOPscience. Please scroll down to see the full text article. 2012 J. Micromech. Microeng. 22 119601 (http://iopscience.iop.org/0960-1317/22/11/119601) View the table of contents for this issue, or go to the journal homepage for more
Download details: IP Address: 211.66.3.87 The article was downloaded on 17/10/2012 at 04:39
Please note that terms and conditions apply.
IOP PUBLISHING
JOURNAL OF MICROMECHANICS AND MICROENGINEERING
doi:10.1088/0960-1317/22/11/119601
J. Micromech. Microeng. 22 (2012) 119601 (1pp)
Erratum: Manipulation and online monitoring of micro-replication quality during injection-compression molding 2012 J. Micromech. Microeng. 22 115003 Wei-Sheng Guan, Han-Xiong Huang and Ze Wu Laboratory for Micro Molding and Polymer Rheology, Center for Polymer Processing Equipment and Intellectualization, South China University of Technology, Guangzhou 510640, People’s Republic of China E-mail:
[email protected]
Received 27 September 2012 Published 16 October 2012 Online at stacks.iop.org/JMM/22/119601
(Some figures may appear in colour only in the online journal)
Incorrect versions of figures 7 and 14 were used in the final version of the paper. The figures should appear as follows.
Figure 14. Simulated local mold strain distribution in the z direction. Pressure of 30 MPa is applied on the projected area of cavity indicated by the dashed line in black.
Figure 7. Linear fit of the maximum cavity pressure versus maximum mold surface strain plot. Compression force: 65–100 kN, compression stroke: 3.5 mm, mounting position of strain sensor: P1.
0960-1317/12/119601+01$33.00
1
© 2012 IOP Publishing Ltd
Printed in the UK & the USA
