Maxi 1060. Standard specification. Hull. • White gelcoat. • The hull produced by
vacuum assisted infusion, with the outer skin from Vinylester and remaining.
Maxi 1060 Standard specification Hull • White gelcoat • The hull produced by vacuum assisted infusion, with the outer skin from Vinylester and remaining laminate in iso-polyester. • Sandwich laminate made of 15 mm PVC core on the topsides above the turn of the bilges. • Reinforcement from a mix between woven and uni-directional roving. • Solid laminate in the keel area as well as the laminate around major through hull fittings. • White topcoat on the hull in all lockers, bilges and similar exposed areas. • Striping with vinyl tape. Internal reinforcement • Moulded hull stiffening and integrated innerliner grid. • Reinforcement from tri-axial and uni-directional glass in tophat sections. • Forward and aft the grid is glued to the hull, while laminated to the hull in the keel area. • Structural bulkheads hand laminated to hull and grid. Keel • 1.87 m draft iron cast fin combined with a lead bulb. • Keel bolted with 11xM20 AISI 316L stainless steel bolts. 10 mm keel washers in stainless steel. Rudder & Steering • Balanced spade rudder. • Hand laminated rudder blade, reinforced bybi-axial and unidirectional E-glass. • Ø60 mm stainless steel rudder stock with wings welded to the stock and laminated to one half of the rudder. • Bottom bearing; acetal needle bearing. • Top bearing; acetal bushing. • Stainless steel tiller with double Ø25 mm tubing and a tiller extension. Deck • White gelcoat. • The deck is produced by vacuum assisted infusion with integrated anti-slip surfaces. • Sandwich laminate made of 15 mm PVC core in all horizontal surfaces. • Deck is glued and bolted to the hull. • White topcoat in all exposed areas. • Glove boxes in the cockpit with teak frames. Deck equipment • Halyard winch • Primary winch • Mainsheet track • Genoa track • Clutch • Clutch • Clutch • Organiser • Genoa car • Mainsheet car • Winch handle • Pad-eyes • Cam-Cleats
2x 30ST 2x 40ST 1x L=1500 mm 2x L=3000 mm 2x double 10–12 mm 2x triple 10–12 mm 1x single 6–8 mm 2x 5-sheaves 2x w/torlon balls 1x w/torlon balls 1x 10" and 1x 12" 4x folding toe-rail Ronstan
Deck openings • Skylight stainless steel frame w/ ventilators: 1x forward cabin 20" square, 1x saloon 16" square. • Portlight, stainless steel frame, opening: 1x toilet, 2x aft cabin. • Stainless steel framed acrylic windows: 4x saloon. • Laminated hatches: 2x anchor locker (fwd & aft), 2x aft storage lockers. • Acrylic hatches 10 mm: 1x companionway sliding hatch, 2x companionway washboards. Other deck gear • Canvas spray hood with stainless tubing. • Aluminium toe-rail. • Guard rail. • Compass. • Flagpole. • 2x halyard bags (supplied loose). Stainless steel deck gear (All AISI 316L acid proof steels) • Pulpit 1x Bow • Pushpit STB/PT stern • Chain plate 1x Forestay, 1x STB/PT shrouds and backstay • Handrail 2x cabin rooftop • Bathing ladder Retractable w/ frame • Mooring Cleats 6x • Mooring rope chafe protection, 6x Interior • Interior in light and dark oak. • Dark oak flooring. Saloon • Couches convertible to berths. Double berth on port when extension pulled out. • Removable saloon table. • Hull cladding in white washed birch. • Curtains fitted in covered tracks. • Panels in ceiling. • Access to storage below seat cushions. • Handrail in ceiling. Galley • Countertop in composite natural minerals and acrylic polymer. • Wood trim on countertop outer edge. • Stainless steel double sink. • Top loaded fridge 40 L. Navigation station • Navigation table w/ storage for charts. Forward cabin • Sleeping cushions incl. infill cushion. • Hull cladding in vinyl. • Blind for skylight. • Ceiling with combination of GRP headliner and detachable panels. • Lockers along hull sides.
Aft Cabin • Sleeping cushions. • Hull cladding in vinyl. • Ceiling made of panels. • Hanging locker and shelves along hull side. • Curtains on s/s pipes. • Door for easy access into engine-room. • Mirror. Heads • Shower discharge pump. • Wet locker aft to heads. • Stainless steel sink with discharge. • Toilet paper holder behind locker door. • Clothes hooks. • Mirror on door.
Mast & Rigging • Mast is fractionally rigged with a keel stepped mast base. Seldén C175x93 mm mast section made of silver anodised aluminium with tapered top. • Mast head: Head box with sheaves for main halyard & topping lift, clevis pin for backstay, Windex. • Hounds: Sheave box for spinnaker pole lift, spinnaker and jib halyard, halyard lead, nose for forestay, Shroud backing plate. • Spreaders: 2 sets of silver anodised aluminium airfoil sectioned spreaders with spreader brackets. Sweep angle 25°. • Deck Level: Boom bracket, Kicker bracket, Deck ring assembly, Tie rod assembly, Mast heel & mast base. • Other: 2x Spinpole eyes. 6x rope slot fittings. Boom • Silver anodised aluminium alloy boom section 146x76 mm. Internal outhaul. 2 single line reefs. • Inboard end: Inboard bracket. • Along boom: 1x kicker slider, 1x sheet slider, 2x lazy-jack slider, 1x lazy-jack cleat. • Outboard end: Outboard bracket. Standing rigging • Discontinuous stainless steel 1x19 strands wire-rigging. Stud-toggle stainless steel rigging screws. • Forestay fork fork, 6 mm. • Intermediate shroud, stem ball swage, 5 mm 5/16" rigging screw. • Upper cap shroud, eye terminal, 7 mm. • Lower cap shroud, fork open, 7 mm, 1⁄ 2" rigging screw. • Permanent backstay, eye fork, 5 mm. • Aft lower shroud, stem ball swage, 7 mm, 7⁄ 16" rigging screw. • Backstay bridle, 7x19 strands, 5 mm. • Furlex 200 S. Running rigging • 1x Main halyard • 1x Genoa halyard • 1x Main topping lift • 1x Main sheet • 2x Genoa / Jib sheets: • 1x Vang Control: • 1x Backstay, • 1x Mainsheet car,
10 mm, 35 m, Dyneema, Shackle. 10 mm, 30 m Dyneema, Snap shackle. 8 mm, 33 m Dyneema, 16/16 rope, Shackle. 10 mm, 30 m, 32/3 rope. 12 mm, 13 m, 32/3 rope. 10 mm, 8 m, 16/16 rope. 10 mm, 10 m, 16/16 rope. 8 mm, 11 m, 16/16 rope.
Boom vang • Seldén rod kicker Type 10 with gas strut.
Sails • Mainsail, 33,2 m2. Crosscut dacron 8 oz. 2 reefs. Nylon sailsliders. Sail numbers. Sail bag. • Mainsail cover. Blue canvas. • Jib, 25,6 m2. 105%. Cross cut dacron 7 oz. UV Protection. Sail bag. Engine & Systems • All through hull fittings close to waterline and below have shutoff ball valves. All hoses are attached with double stainless steel hose clamps. Engine • A three-cylinder Volvo Penta D1-20 C-EVC with a MS25S sail drive. • Freshwater cooled incl. sea water filter. • Teleflex Morse engine controls. • Folding 2-blade propeller. Fuel systems • Fuel tank 78 L of stainless steel. • Fuel level indicator on main switch panel. LPG system • 2-burner LPG stove, gimballed. • LPG bottle storage in cockpit (for EU-standard 3 kg bottle). • Pressure reduction valve 30 mBar. Shut-off valve at stove. Bilge Water system • Electrical bilge pump in heads, Suction point in keel sump, Discharge above waterline. • Manual bilge pump 1 1⁄2" in owners cabin, suction point in keel sump, discharge below sheer line. • Manual bilge pump 1" cockpit, Suction point in engine room. Discharge below sheer line. Freshwater • Watertank polyethylene 115 L. Water level indictor on main switch panel. • Pressurised freshwater pump. • Single lever tap in galley. • Single lever tap with shower hose in heads. Toilet • Toilet bowl. Manual pump. • Stainless steel septic tank 44 L. Navigation lights and interior lights (All navigation lights comply with COLREG 1972.) • Nav lights: 1x stern, white, 1x bow (red & green), 1x anchor light, 1x Tricolour, 1x steaming light. • Reading lamp, chrome, 4x saloon, 2x aft cabin, 2x forward cabin. • Reading lamp, black flexible, 1x navtable. • Ceiling light: 4x saloon, 1x forward cabin, 1x owners cabin. • Locker light, 1x SB locker, 1x port aft locker, 1x cokpit locker. • Light switch, chrome, 1x saloon, 1x forward cabin, 1x owners cabin. Electrical system • 12 Volt electrical system. The battery bank contains 1x starting battery 75 Ah and 3x service batteries 75 Ah. Main switch panel is placed at the navigation table. • Circuit breakers: Nav Lights, Steaming lights, Deck Light, Anchor Light, 3-colour Light, VHF/Radio, Instr/Radar, Autopilot, Aux, Interior Lights 1, Interior Lights 2, Interior Lights, FW pump, Bilge pump, Shower pump, Fridge, Power. • Level gauges: Fuel level, Water level, Voltmeter. • 12 V sockets: 1x navpanel, 1x cockpit, 1x heads. • Main circuit breaker panel placed at companionway. • Fuse groups: Radio, Mem clock, heater, bilge pump, Aux. Main Switches: Engine, Aux. • Battery charge by 115 Amp generator on the engine. Volvo Penta electronic battery charging regulator.
Delivery • Sticker for lifting slings. • Tool bag. • Document Bag containing manuals. Safety • 2x Fire extinguisher 2 kg powder. • Fire-port for engine room. The technical specifications are subject to variance without notice.
